ARTNOVION VERONA BASS TRAP

$569.05 $599.00

No Warranty

The Corner bass trap is the latest in low frequency absorption. This elegant panel integrates a tuneable membrane over a sealed volume, containing a high performance acoustic core. A secondary posterior compartment positions a high density velocity core in the high pressure zone of the room. The panel is completely tuneable, by means of an adjustable weighted membrane, allowing to pin-point the performance of the panel to a target frequency.

The panels' tuneable membrane works in a similar way to a speaker cone, allowing for a much superior - and controlled - performance. A central mass is supported by an elastic membrane - This mass can then be altered to change the resonant frequency of the membrane, stepping the peak performance of the Trap from 57 to 82 Hz.
T.P.D.A. - Artnovion technology

Features

Type:
T.P.D.A. - Artnovion technology
Tuneable Pistonic Diaphragmatic Absorber

Tuneable absorption range:
57Hz to 82Hz.
Hz-by-Hz fine tuning

Purpose

- Room mode control
- Bass ratio control
- Low frequency RT reduction
- Improving low frequency response
- Reducing low frequency time decay

Recommended for

- Vertical Wall Corner

- Small Room Acoustics
- Acoustic pressure zones

- Reducing low frequency time decay

Type:

Tuneable Pistonic Diaphragmatic Absorber

Tuneable absorption range: 58Hz to 82Hz.

.Tuneable weighted Diaphragmatic membrane
.Hz-by-Hz fine tuning
.New fine-tuning possibilities.

Material:
- Natural Wood veneer | Lacquered HMDF | Solid Wood
- Marine grade plywood structural frame
- Calibrated cell acoustic foam

This panels can only be installed on vertical wall corners. Not for ceiling use.

Dimensions:

FG - LW | 595x595x156mm

FG - NW | 595x595x156mm

The front of the panels clips into the bass trap body, leaving easy access to the membrane.

The design of these acoustic cores creates a trap with unprecedented performance and unique calibration – Absorbing more - and from a lower frequency - than anything else on the market.

The Corner Bass Trap will be available in all standard panel fronts – following the lines of the previous HP range. The front of the panels clips in to the bass trap body, leaving easy access to the membrane. The panel is installed on wall corners, with a simple cleat system.

Making the most of our new membrane technology employed in the Sub Trap range.

The new membrane brings new fine-tuning possibilities and even more performance than before. It has been redesigned, forgoing the rounded sides to include a new dedicated sealed-cavity Helmholtz resonator at the back – and also elegantly hiding its cleat fixing system.

For more information on TPDA technology, check out our white paper below.

Available fire rate:
FG | Furniture Grade